High-end car diamond type PDA holder/ GPS mount/ MP4 stand

Product introduction:
1, can be placed with a width of 4.5- Mobile phones, PDAs, GPS, PSP machines, etc. within a range of 10.5 cm can also be placed 4* 7cm photo/ business card.
2,2 installation methods: The oversized suction cup is attached to the windshield and fixed with double-sided tape on the dashboard.
3. The bracket adopts a knob-type 180-degree rotation and can be easily adjusted to the horizontal position./ Longitudinal angle. The PDA stand base can be rotated 360 degrees to adjust the orientation.
4. Thick sponge pads on both sides of the wings, and 2 independent rotatable feet on the bottom, which can be rotated out or retracted to solve the problem of bottom transmission of each model./ Problems with different locations of charging jacks. The clamping is very stable and effectively reduces vibrations on the road.
5. Hydraulic damping wings slowly open after pressing the button./ The combined noise is low.

Installation and fixation method:
1. On the car windshield - super large suction cup vacuum adsorption on it( recommend)
2. Instrument panel - first attach the attached disc base( With double-sided tape) Fix it on the dashboard or other non-smooth surface, and then use the extra large suction cup to suck the disc base.
3. Air conditioning vent - Use the included air conditioning vent clip to clamp it on the air outlet.

The surface is inlaid with diamonds, showing the glory and wealth.!

Can be used as a suction cup and air outlet! Buy one and use it two ways!

​

​

​

​

​

[ Things to note]
1. Safety precautions: Do not place this product close to or install it on the airbag cover, or within the deployment range of the airbag.
2. The windshield base is not designed as a permanent fixture. The best way to use it is to use it within the limits of the foundation to avoid the suction cup from exceeding the maximum limit.
3. Since the tripod, suction cup and embedded jack are not an integral design, when adjusting the angle, you are reminded to hold the end of the suction cup with one hand and adjust the bending angle from the middle of the tripod with the other hand. Be sure to avoid bending. The joint between the two ends is twisted or forced to cause breakage.

​