@@[[ 27A:: PAGEHEAD:: BEGIN]]

­ ​ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ​

!

​

DESOLDERING PUMP

sizemeast( cm): 52x33.5x49/ 32x25x23
Count qty( pcs):400/100
net weight/ gross weight:15/ 16kgs
Product size size( mm): 20x195

30hg/ cm

Instructions:

​

1. Press the piston of the solder suction device downward to lock it.

​

2. Heat the solder joint and use an electric soldering iron to solder and melt it.

​

3. Remove the iron, quickly apply the resistor solder paste on the tin suction cup, and press the button on the solder suction cup.

​

4. If it is not clean once, you can repeat it multiple times.

​

Instructions for use: ​
1. Ensure good solder suction cup piston sealing. Before powering on, insert the soldering suction cup head with your fingers, and press the button on the soldering suction cup head. If the piston does not pop out easily, it means the sealing is good.
2. Aperture tin tips come in different sizes, choose the appropriate specification.
3. The tin suction head is worn and should be replaced with a new one.
4. Before contacting the solder, dip the solder paste into a small amount of rosin to improve the solder fluidity.
5. The soldering head is slightly longer. When the solder melts, take the solder point as the center, then pull out a circle clockwise, and then press the solder suction button.
Notice:
1. Due to differences in light and screen, the color of this product may be slightly different from the picture.
2. Due to manual measurement, there may be 0.5- 2cm error.

​

@@[[ 27A:: PAGEFOOT:: BEGIN]]

­ ­ ­ ­

@@[[ 27A:: PAGEFOOT:: END]]