This type of Hot Wheels is a single induction vibration type, that is, the wheels will light up when they turn, and they turn very beautifully.
Note: Generally, a bicycle or motorcycle can be equipped with 2 Hot Wheels, and a car can be equipped with 4 Hot Wheels. The product is packaged in OPP bags, and the price is for a single package.
Kind tips: The LEDs in Hot Wheels are all solid colors, red light with red stick, green light with green stick, blue light with blue stick, and yellow light with yellow stick.

[ Product name] Fluorescent Stick Type Hot Wheels Valve Light
[ line] Independent circuit design, dynamic sensing circuit, and light-emitting circuit composition
[ color] Red, yellow, green, blue( Colorful, the price is higher)
[ Material] plastic
[ Package] Blister card packaging
[ power supply] There are 3 AG10 button batteries in each lamp, and the AG10 battery is connected

A: This kind of Hot Wheels is a single induction vibration type, that is, the wheels will light up when they turn, and they turn very beautifully.
B: Fine workmanship
C: There is a waterproof rubber pad, which can be screwed onto the wheel valve.
D: The built-in adapter is basically suitable for various vehicle valves and can be used in cars, motorcycles, and mountain bikes.( Ordinary bicycle valves can also be installed)

Uses 3 AG10 button batteries
( If you ride at 25 yards, it will look like a circle, and at 30 yards, it will look like a circle.)

Precautions for installing glow stick type Hot Wheels batteries! Be sure to read before installation!
There are two points you need to pay attention to when installing after receiving the goods. First, when installing the battery, the positive terminal must be downwards.( The side with the words is the positive pole) , do not remove the insulating transparent plastic sheet inside the lamp case. It is used to prevent the battery from being short-circuited with the metal of the lamp case. Otherwise, the metal short-circuit between the battery and the lamp case will cause the battery to discharge and heat, and the battery will run out of power in a few minutes. The second lamp holder It is normal for the circuit board inside to be loose. Be careful not to let the circuit board fall when removing the lamp head.!